Create script to login to the appliance, save the config, and copy it (or mail it).This post will address point (2), because I didn't want to re-do all the zoning from scratch. If you go the single SAN switch route, then be careful, some of the cheaper SAN switches have only one power supply - and thus represent a single point of failure for your backup solution, not good - so, because these cheaper SAN switches only have one power supply, they are meant to be used in pairs, i.Follow the on-screen prompts to back up the switch. This switch may be specified to format the output with the device's name rather than the host name. It delivers market-leading stacking density with up to 12 switches (576 1 GbE and 48 10 GbE ports) per stack and combines chassis-level. Before installing the new switch, the zoning information should be cleared to ensure that a zoning mismatch does not occur. I hadn't the possibilty to test the script until now. Backup up your brocade switch config 01 July 2009 By klavs 0 I wanted to backup a brocade san switch configuration, and tried SaveSimplyYourSan - but it wouldn't do ssh - and using telnet, uploading config to ftp - is too unsecure for my taste. Brocade san switch backup script Password recovery procedure for Brocade 300, 5100, 5300 switches and the Brocade Encryption Switch To recover a password on a Brocade 300, 5100, 5300, or a Brocade Encryption Switch, follow these steps: 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |